Display Blacklist User - HP FlexNetwork 7500 Series Command Reference Manual

Related commands
blacklist ipv6

display blacklist user

Use display blacklist user to display user blacklist entries.
Syntax
display blacklist user [ user-name ] [ count ]
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
user-name: Specifies a user by the username, a case-sensitive string of 1 to 55 characters. If you do
not specify a user, this command displays all user blacklist entries.
count: Displays the number of matching user blacklist entries.
Examples
# Display all user blacklist entries.
<Sysname> display blacklist user
Username
Alex
Bob
Cary
# Display the number of user blacklist entries.
<Sysname> display blacklist user count
Totally 3 blacklist entries.
# Display the user blacklist entry for user Alex.
<Sysname> display blacklist user Alex
Username
Alex
Table 87 Command output
Field
Username
Type
TTL(sec)
Dropped
Totally 3 blacklist entries
Type TTL(sec)
Manual 10
Manual 123
Manual Never
Type TTL(sec)
Manual 10
Description
Username in the user blacklist entry.
Type of the user blacklist entry. Only the manual mode is supported.
Remaining aging time of the user blacklist entry, in seconds. If no aging
time is set for the entry, this field displays Never.
Number of dropped packets sourced from the user.
Total number of user blacklist entries.
Dropped
353452
4294967295
14478
Dropped
353452
556