Dot1X Eapol Untag - HP FlexNetwork 7500 Series Command Reference Manual

undo dot1x ead-assistant url
Default
No redirect URL exists for EAD assistant.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
url-string: Specifies the redirect URL, a case-sensitive string of 1 to 256 characters in the format
http://string or https://string. If the specified URL does not start with http:// or https://, the URL is
considered to start with http:// by default.
Usage guidelines
When an unauthenticated user uses a Web browser to access any network other than the free IP, the
device redirects the HTTP or HTTPS requests of the user to the redirect URL.
The redirect URL must be on the free IP subnet.
If you execute this command multiple times, the most recent configuration takes effect.
To redirect the HTTPS requests of 802.1X users, use the http-redirect https-port command to
specify the HTTPS redirect listening port. For information about the http-redirect https-port
command, see HTTP redirect commands in Layer 3—IP Services Command Reference.
Examples
# Configure the redirect URL as http://test.com.
<Sysname> system-view
[Sysname] dot1x ead-assistant url http://test.com
Related commands
display dot1x
dot1x ead-assistant enable
dot1x ead-assistant free-ip
http-redirect https-port (Layer 3—IP Services Command Reference)

dot1x eapol untag

Use dot1x eapol untag to enable the device to send 802.1X protocol packets out of a port without
VLAN tags.
Use undo dot1x eapol untag to restore the default.
Syntax
dot1x eapol untag
undo dot1x eapol untag
Default
Whether the device sends 802.1X protocol packets out of a port with VLAN tags depends on the
configuration in the VLAN module.
180