Table of Contents
Advertisement
Syntax
free ssh { user-ip { ip-address | ipv6 ipv6-address } [ port port-number ] | user-pid pid-number |
username username }
Views
User view
Predefined user roles
network-admin
mdc-admin
Parameters
user-ip: Specifies the user IP address of the SSH sessions to be disconnected.
ip-address: Specifies the user IPv4 address of the SSH sessions to be disconnected.
ipv6 ipv6-address: Specifies the user IPv6 address of the SSH sessions to be disconnected.
port port-number: Specifies the source port of the SSH session to be disconnected, in the range of 1
to 65535. If you do not specify a source port, this command disconnects all SSH sessions using the
specified IP address.
user-pid pid-number: Specifies the user process ID of the SSH session to be disconnected, in the
range of 1 to 2147483647. To view the user process ID of an SSH session, use the display ssh
server session command.
username username: Specifies the username of the SSH session to be disconnected. To view the
username of an SSH session, use the display ssh server session command.
Examples
# Disconnect the SSH sessions with user IPv4 address 192.168.15.45.
<Sysname> free ssh user-ip 192.168.15.45
Releasing SSH connection. Continue? [Y/N]:y
# Disconnect the SSH sessions with user IPv6 address 2000::11.
<Sysname> free ssh user-ip ipv6 2000::11
Releasing SSH connection. Continue? [Y/N]:y
# Disconnect the SSH session with user process ID 417.
<Sysname> free ssh user-pid 417
Releasing SSH connection. Continue? [Y/N]:y
# Disconnect the SSH session with username sshuser.
<Sysname> free ssh username sshuser
Releasing SSH connection. Continue? [Y/N]:y
Related commands
display ssh server session
scp server enable
Use scp server enable to enable the SCP server.
Use undo scp server enable to disable the SCP server.
Syntax
scp server enable
undo scp server enable
443
Advertisement
Table of Contents
