Ssh Client Source - HP FlexNetwork 7500 Series Command Reference Manual

ssh client source

Use ssh client source to configure the source IPv4 address for SSH packets that are sent by the
Stelnet client.
Use undo ssh client source to restore the default.
Syntax
ssh client source { interface interface-type interface-number | ip ip-address }
undo ssh client source
Default
The source IPv4 address for SSH packets is not configured. The Stelnet client uses the primary IPv4
address of the output interface specified in the routing entry as the source address of the SSH
packets.
Views
System view
Predefined user roles
network-admin
mdc-admin
Parameters
interface interface-type interface-number: Specifies a source interface by its type and number. The
SSH packets use the primary IPv4 address of the interface as their source address.
ip ip-address: Specifies a source IPv4 address.
Usage guidelines
This command takes effect on all Stelnet connections. The source IPv4 address specified in the
ssh2 command takes effect only on the current Stelnet connection. If you specify the source IPv4
address both in this command and the ssh2 command, the source IPv4 address specified in the
ssh2 command takes effect.
If you execute this command multiple times, the most recent configuration takes effect.
Examples
# Specify 192.168.0.1 as the source IPv4 address for SSH packets.
<Sysname> system-view
[Sysname] ssh client source ip 192.168.0.1
Related commands
display ssh client source
ssh2
Use ssh2 to establish a connection to an IPv4 Stelnet server.
Syntax
In non-FIPS mode:
ssh2 server [ port-number ] [ vpn-instance vpn-instance-name ] [ identity-key { dsa |
ecdsa-sha2-nistp256 | ecdsa-sha2-nistp384 | rsa | { x509v3-ecdsa-sha2-nistp256 |
x509v3-ecdsa-sha2-nistp384 } pki-domain domain-name } | prefer-compress zlib |
prefer-ctos-cipher { 3des-cbc | aes128-cbc | aes128-ctr | aes128-gcm | aes192-ctr | aes256-cbc
| aes256-ctr | aes256-gcm | des-cbc } | prefer-ctos-hmac { md5 | md5-96 | sha1 | sha1-96 |
489