Display Arp Source-Mac - HP FlexNetwork 7500 Series Command Reference Manual

Predefined user roles
network-admin
mdc-admin
Parameters
threshold-value: Specifies the threshold for source MAC-based ARP attack detection. The value
range for this argument is 1 to 5000.
Examples
# Set the threshold for source MAC-based ARP attack detection to 30.
<Sysname> system-view
[Sysname] arp source-mac threshold 30

display arp source-mac

Use display arp source-mac to display ARP attack entries detected by source MAC-based ARP
attack detection.
Syntax
In standalone mode:
display arp source-mac { interface interface-type interface-number | slot slot-number }
In IRF mode:
display arp source-mac { chassis chassis-number slot slot-number | interface interface-type
interface-number }
Views
Any view
Predefined user roles
network-admin
network-operator
mdc-admin
mdc-operator
Parameters
interface interface-type interface-number: Specifies an interface by its type and number.
slot slot-number: Specifies a card by its slot number. If you do not specify a card, this command
displays ARP attack entries for the active MPU. (In standalone mode.)
chassis chassis-number slot slot-number: Specifies a card on an IRF member device. The
chassis-number argument represents the member ID of the IRF member device. The slot-number
argument represents the slot number of the card. If you do not specify a card, this command displays
ARP attack entries for the global active MPU. (In IRF mode.)
Examples
# Display the ARP attack entries detected by source MAC-based ARP attack detection on
Ten-GigabitEthernet 1/0/1.
<Sysname> display arp source-mac interface ten-gigabitethernet 1/0/1
Source-MAC
23f3-1122-3344
VLAN ID Interface
4094 XGE1/0/1
625
Aging-time
10