General Information; General Safety; Service Rules - Honda CX650C 1983 Shop Manual

Table of Contents

Advertisement

1
GENERAL SAFETY
1
SERVICE RULES
1
TORQUE VALUES
1-7
TOOLS
1-9
/
" 1 - 1
CABLE
Egr
HARNESS
ROUTING
1-2
EMISSION CONTROL SYSTEM
11-42
"1-3
EMISSION CONTROL
INFORMATION LABEL
1-12
4
-5
GENERAL SAFETY
If the engine must be running to do some work, make
sure the area is well-ventilated. Never run the engine
i~z a closed area. The exhalist contains poisonous
carbon monoxide gas.
Gasoline is extremely flammable and is explosive
under certain conditions. Do not smoke or a61ow
jlarnes or sparks in your working area.
The battery electrolyte contaitzs stdlfttric acid. Protect
your eyes, skin and clothing. In case of contact, Jlicsh
thoroughly with water and call a iloctor if electrolyte
gets in your eyes.
The battery generates hydrogen gas which can be
highly explosive. Do not smoke or allow flames or
sparks near the battery, especially while charging it.
SERVICE RULES
1. Use genuine HONDA or HONDA-recommended parts and lubricants or their equivalents. Parts that do not meet HONBA's
design specificaiions may damage the motorcycle.
2. Use the special tools designed for this product.
3. Use only metric tools when servicing this motorcycle. Metric bolts, nuts, and screws are not interchangeable with English
fasteners. The use of incorrect tools and fasteners may damage the motorcycle.
4. Instali new gaskets, O-rings, cotter pins, lock p,lates, etc. when reassembling.
5. When tightening bolts or nuts, begin with larger-diameter or inqer bolts first, and tighten t o the specified torque diagonally
in 2-3 steps, unless a particular sequence is specified.
6. Clean parts in non-fiarnmable or high flash point solvent upon disassembly. Lubricate any sliding surfaces before
reassembly.
7.
After reassembly, check all parts for proper installation and operation.
8.
Route all electrical wires a s shown on page 1-9 Cable and Harness Routing and always away from sharp edges and areas
where they might be pinched between moving parts.
Date of Issue: December,
1982
O
HONDA MOTOR
CO.,
LTD.

Advertisement

Table of Contents
loading

Table of Contents