Honda CX650C 1983 Shop Manual page 247

CX650C
HYDRAULIC BRAKE
m -
-
COLLAR
COLLAR ROOTS PISTON BOOTS
ASSEMB bV
If the piston boots are hardened or deteriorated,
replace them with new ones. The piston seals must
be replaced with new ones whenever they are
removed. Coat the seals with silicone grease or brake
fluid before assembly.
lnstall the pistons with the dished ends toward the
pads. Then install the piston boots.
lnstall the collar boots and collar 171aking sure that
the boots are seated in the collar and caliper grooves
proper1 y.
lnstall the pad spring and pads.
lnstall the caliper pivot bolt, if i t was removed.
TORQUE: 25-36
IV-wt
(2.5-3.0
kg-m, 48-22 h-lb)
PAD S P ~ I N C ; 0 1
16'
SEALS PISTONS
PIVOT BOOT
PAD
SPRING
INSTAl_LATION
Install the pivot boot and pad spring as shown.
Apply silicone grease or brake fluid to the caliper
pivot bolt.
lnstali the caliper assembly over the brake disc so
that the disc i s positioned ktween the pads.
CAUTION
- p - . p
~ ~ f i r l not
to clamage
the pads
I.nstall the caliper bolt.
TORQUE: 20-25 N*m
(2.0-2.5
kg-m,
'14-18 f t
Connect the brake hose and fill the
reservoir. Bleed the front brake system
brake
(page
fluid
1 14-41.
CALIPER BOLT
Date of Issue: December,
1982
O HONDA MOTOR CO., LTD.