Ignition Coil; Primary Coil Inspection; Secondary Coil Inspection - Honda CX650C 1983 Shop Manual

IGNITION
SYSTEM
PRIMARY GO1 L INSPECTION
Remove the fuel tank (page 4-1 5).
Check the resistance between the leads with an
ohmmeter as shown.
RESISTANCE: 2-3 ohms
SECONDARY CO1
k
INSPECTION
The secondary coil inspection method differs de-
pending on whether or not there i s a mark on the
ignition coil body. Look for an "S" mark before
testing.
WITH "S" MARK
Measure the resistance between the blacklwhite
coupler terminal and the high tension terminal.
NOTE
e
Use a Kowa Tester (Tti-5H) or Sanwa Tester
(07308-0020000). l
e
Use new test batteries for this
test.
--
1
Connect the negative probe of the tester to the
coupler terminal and positive probe to the high
tension terminal and measure the resistance.
RESISTANCE:
SAIVWA
TESTER: 200-350
k!2
KOWA TESTER: 50-200
k!2
Change the tester polarities and measure the resis-
tance.
RESISTANCE: ohms
Replace the ignition coil i f the resistance limits are
not met.
PR INIARV LEAD COUPLE W
"S" MAR K
Date of Issue: December, 1982
O HONDA MOTOR CO., LTD.