Set Port Negotiation Command - Avaya P130 User Manual

0-7
Example:
To set the priority level for port 2 on module 1 to 7:
P130-1# set port level 1/2 7
Port 1/2 port level set to 7.

Set port negotiation Command

Use the set port negotiation command to enable or disable the link
negotiation protocol on the specified port. This command applies to Fast Ethernet or
Gigabit Ethernet ports. When negotiation is enabled, the speed and duplex of the
Fast Ethernet ports are determined by auto-negotiation. If autonegotiation is
disabled, you can set these port parameters using the relevant CLI commands (if
autonegotiation is enabled, these commands have no effect).
The syntax for this command is:
set port negotiation <mod_num/port_num> {enable | disable}
mod_num
port_num
enable
disable
Avaya P130 User's Guide
Priority level
Module number
Number of the port on the module
Enable the link negotiation protocol
Disable the link negotiation protocol
Chapter 6 Avaya P130 CLI
71