Port Commands; Show Port Command - Avaya P130 User Manual

Chapter 6 Avaya P130 CLI

Port Commands

Show port Command

Use the show port command to display port status.
The syntax for this command is:
P130-N> show port [mod_num[/port_num]]
mod_num
port_num
Example:
To display the status for port 4 on module 1:
P130-N> show port 1/4
Port Name
---- -----
1/4 NoName disabled 203
Show Port Output Fields:
Port
Name
Status
VLAN
Level
Neg
Duplex
Speed
Type
66
Module number (optional). If you do not specify a
number, the ports on all modules are shown.
Number of the port on the module (optional). If you
do not specify a number, all the ports on the module
are shown.
Status VLAN
------ ----- ------ -----
Field
Module and port number
Name of the port
Status of the port (connected, faulty, disabled)
VLAN ID of the port
Priority level of the port (normal or high)
The negotiation status of the port (enable, disable)
Duplex setting for the port (fdx, hdx)
Speed setting for the port (10, 100, 1000)
Port type, for example, 10/100BaseTX, GBIC_SX,
GBIC_LX, GBIC_not present, GBIC_unknown, 1000Base-
T
Level Neg Dup.
---- ------ ------
normal enable full
Description
Spd. Type
100M 100BaseT
Avaya P130 User's Guide