Show Dscp Command; Ip Access-Group Command - Avaya P130 User Manual

Chapter 6 Avaya P130 CLI

Show dscp Command

Use the show dscp command to see the DSCP table.
The syntax for this command is:
show dscp
Example:
P130-1# show dscp
set qos trust trust-cos
DSCP table validity status: Valid
DSCP Action Precedence ApplicStatus
---- ------ ---------- ------------- ------------- ----------
5 fwd3
21 fwd6
45 fwd7
60 fwd1

ip access-group Command

Use the ip access-group command to activate a specific policy list. To
deactivate the policy list, use the no version of this command.
The syntax for this command is:
[no] [ip] access-group <policy-list-number>[<default-action>]
<priority-list-number>
<default-action>
P130-1# ip access-group 101
Policy list 101 was activated successfully
120
mandatory applicable
mandatory applicable
mandatory applicable
mandatory applicable
Integer (100..199)
default-action-deny|default-action-permit
ApplicType Name
quasi-static DSCP #5
quasi-static DSCP #21
quasi-static DSCP #45
quasi-static DSCP #60
Avaya P130 User's Guide