Snmp-Server Enable Traps Isis - Cisco Catalyst 3650 series Command Reference Manual

snmp-server enable traps isis

To enable intermediate system-to-intermediate system (IS-IS) link-state routing protocol traps, use the
snmp-server enable traps isis command in global configuration mode. Use the no form of this command to
return to the default setting.
snmp-server enable traps isis [errors | state-change]
no snmp-server enable traps isis [errors | state-change]
Syntax Description
errors
state-change
Command Default
The sending of IS-IS traps is disabled.
Command Modes
Global configuration
Command History
Release
Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
Specify the host (NMS) that receives the traps by using the snmp-server host global configuration command.
If no trap types are specified, all trap types are sent.
Informs are not supported in SNMPv1.
Note
To enable more than one type of trap, you must enter a separate snmp-server enable traps command for
each trap type.
Examples This example shows how to generate IS-IS error traps:
Device(config)# snmp-server enable traps isis errors
(Optional) Enables IS-IS error traps.
(Optional) Enables IS-IS state change traps.
Modification
This command was introduced.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
snmp-server enable traps isis
543