Snmp-Server Enable Traps Transceiver - Cisco Catalyst 3650 series Command Reference Manual

snmp-server enable traps transceiver

snmp-server enable traps transceiver
To enable SNMP transceiver traps, use the snmp-server enable traps transceiver command in global
configuration mode. Use the no form of this command to return to the default setting.
snmp-server enable traps transceiver {all}
no snmp-server enable traps transceiver {all}
Syntax Description
all
Command Default
The sending of SNMP transceiver traps is disabled.
Command Modes
Global configuration
Command History
Release
Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
Specify the host (NMS) that receives the traps by using the snmp-server host global configuration command.
If no trap types are specified, all trap types are sent.
Informs are not supported in SNMPv1.
Note
To enable more than one type of trap, you must enter a separate snmp-server enable traps command for
each trap type.
Examples This example shows how to set all SNMP transceiver traps:
Device(config)# snmp-server enable traps transceiver all
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
556
(Optional) Enables all SNMP transceiver traps.
Modification
This command was introduced.