Filter (Erspan) - Cisco Catalyst 3650 series Command Reference Manual

filter (ERSPAN)

To configure the Encapsulated Remote Switched Port Analyzer (ERSPAN) source VLAN filtering when the
ERSPAN source is a trunk port, use the filter command in ERSPAN monitor source session configuration
mode. To remove the configuration, use the no form of this command.
filter {ip access-group {standard-access-list | extended-access-list | acl-name} | ipv6 access-group acl-name
| mac access-group acl-name | vlan vlan-id [,] [-]}
no filter {ip [access-group | [standard-access-list | extended-access-list | acl-name]] | ipv6 [access-group]
| mac [access-group] | vlan vlan-id [,] [-]}
Syntax Description
ip
access-group
standard-access-list
extended-access-list
acl-name
ipv6
mac
vlan vlan-ID
,
-
Command Default
Source VLAN filtering is not configured.
Command Modes
ERSPAN monitor source session configuration mode (config-mon-erspan-src)
Command History
Release
Cisco IOS XE Denali 16.3.1
Usage Guidelines
You cannot include source VLANs and filter VLANs in the same session.
Specifies the IP access control rules.
Specifies an access control group.
Standard IP access list.
Extended IP access list.
Access list name.
Specifies the IPv6 access control rules.
Specifies the media access control (MAC) rules.
Specifies the ERSPAN source VLAN. Valid values are from 1 to 4094.
(Optional) Specifies another VLAN.
(Optional) Specifies a range of VLANs.
Modification
This command was introduced.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
filter (ERSPAN)
485