Show Platform Software Swspan - Cisco Catalyst 3650 series Command Reference Manual

show platform software swspan

To display switched port analyzer (SPAN) information, use the show platform software swspan command
in privileged EXEC mode.
show platform software swspan {switch} {{{F0 | FP active} counters}| R0 | RP active} {destination
sess-id session-ID | source sess-id session-ID}
Syntax Description
switch
F0
FP
active
counters
R0
RP
destination sess-id session-ID
source sess-id session-ID
Command Modes
Privileged EXEC (#)
Command History
Release
Cisco IOS XE Denali 16.1.1
Usage Guidelines
If the session number does not exist or if the SPAN session is a remote destination session, the command
output will display the following message "% Error: No Information Available."
Examples The following is sample output from the show platform software swspan FP active source command:
Switch# show platform software swspan FP active source sess-id 0
Showing SPAN source detail info
Displays information about the switch.
Displays information about the Embedded Service Processor (ESP) slot
0.
Displays information about the ESP.
Displays information about the active instance of the ESP or the Route
Processor (RP).
Displays the SWSPAN message counters.
Displays information about the RP slot 0.
Displays information the RP.
Displays information about the specified destination session.
Displays information about the specified source session.
Modification
This command was introduced in a release prior to Cisco IOS XE
Denali 16.1.1.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
show platform software swspan
529