Network-Policy - Cisco Catalyst 3650 series Command Reference Manual
Cisco ios xe everest 16.5.1a
Hide thumbs
Also See for Catalyst 3650 series:
- Hardware installation manual (126 pages) ,
- Configuration manual (94 pages) ,
- Manual (94 pages)
Table of Contents
Advertisement
network-policy
To apply a network-policy profile to an interface, use the network-policy command in interface configuration
mode. To remove the policy, use the no form of this command.
network-policy profile-number
no network-policy
Syntax Description
profile-number
Command Default
No network-policy profiles are applied.
Command Modes
Interface configuration
Command History
Release
Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
Use the network-policy profile number interface configuration command to apply a profile to an interface.
You cannot apply the switchport voice vlan command on an interface if you first configure a network-policy
profile on it. However, if switchport voice vlan vlan-id is already configured on the interface, you can apply
a network-policy profile on the interface. The interface then has the voice or voice-signaling VLAN
network-policy profile applied.
Examples
This example shows how to apply network-policy profile 60 to an interface:
Device(config)# interface gigabitethernet1/0/1
Device(config-if)# network-policy 60
The network-policy profile number to apply to the interface.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
network-policy
Modification
This command was introduced.
55
Advertisement
Table of Contents
