Macsec Network-Link - Cisco Catalyst 3650 series Command Reference Manual

macsec network-link

macsec network-link
To enable MKA MACsec configuration on the uplink interfaces, use the macsec network-link command on
the interface. To disable it, use the no form of this command.
macsec network-link
Syntax Description
macsec network-link
Command Default
macsec network-link is disabled.
Command Modes
Interface configuration
Command History
Release
Cisco IOS XE Denali 16.3.1
Usage Guidelines
Examples
This example shows how to configure MACsec MKA on an interface using the EAP-TLS authentication
protocol:
Switch#configure terminal
Switch(config)# int G1/0/20
Switch(config-if)# macsec network-link
Switch(config-if)# end
Switch#
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
782
Enables MKA MACsec configuration on device interfaces using
EAP-TLS authentication protocol.
Modification
This command was introduced.