L2Protocol-Tunnel Cos - Cisco Catalyst 3650 series Command Reference Manual

l2protocol-tunnel cos

To configure class of service (CoS) value for all tunneled Layer 2 protocol packets, use the l2protocol-tunnel
cos global configuration command. To return to the default setting, use the no form of this command.
l2protocol-tunnel cos value
no l2protocol-tunnel cos
Syntax Description
value
Command Default
The default is to use the CoS value configured for data on the interface. If no CoS value is configured, the
default is 5 for all tunneled Layer 2 protocol packets.
Command Modes
Global configuration
Command History
Release
Cisco IOS XE 3.3SE
Usage Guidelines
When enabled, the tunneled Layer 2 protocol packets use this CoS value.
The value is saved in NVRAM.
Examples
This example shows how to configure a Layer-2 protocol-tunnel CoS value of 7:
Device(config)# l2protocol-tunnel cos 7
CoS priority value for tunneled Layer 2 protocol packets. If a CoS value is configured for
data packets for the interface, the default is to use this CoS value. If no CoS value is configured
for the interface, the default is 5. The range is 0 to 7, with 7 being the highest priority.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
Modification
This command was introduced.
l2protocol-tunnel cos
1021