Snmp-Server Enable Traps Port-Security - Cisco Catalyst 3650 series Command Reference Manual

snmp-server enable traps port-security

To enable SNMP port security traps, use the snmp-server enable traps port-security command in global
configuration mode. Use the no form of this command to return to the default setting.
snmp-server enable traps port-security [trap-rate value]
no snmp-server enable traps port-security [trap-rate value]
Syntax Description
trap-rate value
Command Default
The sending of port security SNMP traps is disabled.
Command Modes
Global configuration
Command History
Release
Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
Specify the host (NMS) that receives the traps by using the snmp-server host global configuration command.
If no trap types are specified, all trap types are sent.
Informs are not supported in SNMPv1.
Note
To enable more than one type of trap, you must enter a separate snmp-server enable traps command for
each trap type.
Examples This example shows how to enable port-security traps at a rate of 200 per second:
Device(config)# snmp-server enable traps port-security trap-rate 200
(Optional) Sets the maximum number of port-security traps sent per second. The
range is from 0 to 1000; the default is 0 (no limit imposed; a trap is sent at every
occurrence).
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
snmp-server enable traps port-security
Modification
This command was introduced.
549