Command Reference, Cisco Ios Xe Everest 16.5.1A (Catalyst 3650 Switches - Cisco Catalyst 3650 series Command Reference Manual

Received 0 broadcasts (0 multicasts)
0 runts, 0 giants, 0 throttles
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored
0 watchdog, 0 multicast, 0 pause input
0 input packets with dribble condition detected
0 packets output, 0 bytes, 0 underruns
0 output errors, 0 collisions, 1 interface resets
0 unknown protocol drops
0 babbles, 0 late collision, 0 deferred
0 lost carrier, 0 no carrier, 0 pause output
0 output buffer failures, 0 output buffers swapped out
This is an example of output from the show interfaces accounting command:
This is an example of output from the show interfaces capabilities command for an interface:
This is an example of output from the show interfaces interface description command when the interface
has been described as Connects to Marketing by using the description interface configuration command:
Device# show interfaces gigabitethernet1/0/2 description
Interface
Gi1/0/2
This is an example of output from the show interfaces etherchannel command when port channels are
configured on the switch:
This is an example of output from the show interfaces interface-id pruning command when pruning is enabled
in the VTP domain:
Device# show interfaces gigabitethernet1/0/2 pruning
Port Vlans pruned for lack of request by neighbor
Gi1/0/2 3,4
Port Vlans traffic requested of neighbor
Gi1/0/2 1-3
This is an example of output from the show interfaces stats command for a specified VLAN interface:
Device# show interfaces vlan 1 stats
Switching path Pkts In
Processor 1165354
Route cache
Total 1165354
This is an example of partial output from the show interfaces status command. It displays the status of all
interfaces:
These are examples of output from the show interfaces status command for a specific interface when private
VLANs are configured. Port 22 is configured as a private-VLAN host port. It is associated with primary
VLAN 20 and secondary VLAN 25:
Device# show interfaces gigabitethernet1/0/22 status
Port Name Status
Gi1/0/22 connected
In this example, port 20 is configured as a private-VLAN promiscuous port. The display shows only the
primary VLAN 20:
Device# show interfaces gigabitethernet1/0/20 status
Port Name Status
Gi1/0/20 connected
This is an example of output from the show interfaces status err-disabled command. It displays the status
of interfaces in the error-disabled state:
Device# show interfaces status err-disabled
Port Name Status
Gi1/0/2 err-disabled
Status Protocol Description
up down
Chars In Pkts Out
136205310 570800
0 0
136205310 570800
Vlan Duplex
20,25 a-full
Vlan Duplex
20 a-full
Reason
gbic-invalid

Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)

Connects to Marketing
Chars Out
91731594
0 0
91731594
Speed Type
a-100 10/100BaseTX
Speed Type
a-100 10/100BaseTX
show interfaces
79