Command Reference, Cisco Ios Xe Everest 16.5.1A (Catalyst 3650 Switches - Cisco Catalyst 3650 series Command Reference Manual

start-period seconds
supp-timeout seconds
tx-period seconds
Command Default
Periodic reauthentication and periodic rate-limiting are done.
Command Modes
Interface configuration
Command History
Release
Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
You should change the default value of this command only to adjust for unusual circumstances such as
unreliable links or specific behavioral problems with certain clients and authentication servers.
The dot1x timeout reauth-period interface configuration command affects the behavior of the switch only
if you have enabled periodic re-authentication by using the dot1x reauthentication interface configuration
command.
During the quiet period, the switch does not accept or initiate any authentication requests. If you want to
provide a faster response time to the user, enter a number smaller than the default.
When the ratelimit-period is set to 0 (the default), the switch does not ignore EAPOL packets from clients
that have been successfully authenticated and forwards them to the RADIUS server.
Configures the interval, in seconds, between two successive
EAPOL-Start frames when they are being retransmitted.
The range is from 1 to 65535. The default is 30.
In Cisco IOS Release 15.2(5)E, this command is only available in
the supplicant mode. If the command is applied in any other mode,
the command misses from the configuration.
Sets the authenticator-to-supplicant retransmission time for all EAP
messages other than EAP Request ID.
The range is from 1 to 65535. The default is 30.
Configures the number of seconds between retransmission of EAP
request ID packets (assuming that no response is received) to the
client.
• The range is from 1 to 65535. The default is 30.
• If an 802.1X packet is sent to the supplicant and the supplicant
does not send a response after the retry period, the packet will
be sent again.

Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)

dot1x timeout
Modification
This command was introduced.
755