Show Sdm Prefer - Cisco Catalyst 3650 series Command Reference Manual

show sdm prefer

show sdm prefer
To display information about the templates that can be used to maximize system resources for a particular
feature, use the show sdm prefer command in privileged EXEC mode. To display the current template, use
the command without a keyword.
show sdm prefer [advanced]
Syntax Description
advanced
Command Default
No default behavior or values.
Command Modes
Privileged EXEC
Command History
Release
Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
If you did not reload the switch after entering the sdm prefer global configuration command, the show sdm
prefer privileged EXEC command displays the template currently in use and not the newly configured
template.
The numbers displayed for each template represent an approximate maximum number for each feature resource.
The actual number might vary, depending on the actual number of other features configured. For example,
in the default template if your device had more than 16 routed interfaces (subnet VLANs), the number of
possible unicast MAC addresses might be less than 6000.
Examples The following is sample output from the show sdm prefer command:
Device# show sdm prefer
Showing SDM Template Info
This is the Advanced template.
Number of VLANs:
Unicast MAC addresses:
Overflow Unicast MAC addresses:
IGMP and Multicast groups:
Overflow IGMP and Multicast groups:
Directly connected routes:
Indirect routes:
Security Access Control Entries:
QoS Access Control Entries:
Policy Based Routing ACEs:
Netflow ACEs:
Input Microflow policer ACEs:
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
968
(Optional) Displays information on the advanced template.
Modification
This command was introduced.
4094
32768
512
8192
512
32768
7680
3072
3072
1024
1024
256