Snmp-Server Enable Traps Bulkstat - Cisco Catalyst 3650 series Command Reference Manual

snmp-server enable traps bulkstat

snmp-server enable traps bulkstat
To enable data-collection-MIB traps, use the snmp-server enable traps bulkstat command in global
configuration mode. Use the no form of this command to return to the default setting.
snmp-server enable traps bulkstat [collection | transfer]
no snmp-server enable traps bulkstat [collection | transfer]
Syntax Description
collection
transfer
Command Default
The sending of data-collection-MIB traps is disabled.
Command Modes
Global configuration
Command History
Release
Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
Specify the host (NMS) that receives the traps by using the snmp-server host global configuration command.
If no trap types are specified, all trap types are sent.
Informs are not supported in SNMPv1.
Note
To enable more than one type of trap, you must enter a separate snmp-server enable traps command for
each trap type.
Examples This example shows how to generate data-collection-MIB collection traps:
Device(config)# snmp-server enable traps bulkstat collection
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
536
(Optional) Enables data-collection-MIB collection traps.
(Optional) Enables data-collection-MIB transfer traps.
Modification
This command was introduced.