Command Reference, Cisco Ios Xe Everest 16.5.1A (Catalyst 3650 Switches - Cisco Catalyst 3650 series Command Reference Manual

set
When you configure the set dscp coscommand, note the following: The CoS value is a 3-bit field, and the
DSCP value is a 6-bit field. Only the three bits of the CoS field are used.
When you configure the set dscp qos-group command, note the following:
• The valid range for the DSCP value is a number from 0 to 63. The valid value range for the QoS group
• If a QoS group value falls within both value ranges (for example, 44), the packet-marking value is copied
• If QoS group value exceeds the DSCP range (for example, 77), the packet-marking value is not be copied
The set qos-group command cannot be applied until you create a service policy in policy-map configuration
mode and then attach the service policy to an interface or ATM virtual circuit (VC).
To return to policy-map configuration mode, use the exit command. To return to privileged EXEC mode, use
the end command.
Examples This example shows how to assign DSCP 10 to all FTP traffic without any policers:
Device(config)# policy-map policy_ftp
Device(config-pmap)# class-map ftp_class
Device(config-cmap)# exit
Device(config)# policy policy_ftp
Device(config-pmap)# class ftp_class
Device(config-pmap-c)# set dscp 10
Device(config-pmap)# exit
You can verify your settings by entering the show policy-map privileged EXEC command.
Related Commands
Command
class
policy-map
show policy-map

Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)

666
is a number from 0 to 99.
and the packets is marked.
and the packet is not marked. No action is taken.
Description
Defines a traffic classification match criteria for the specified class-map name.
Creates or modifies a policy map that can be attached to multiple physical
ports or SVIs and enters policy-map configuration mode.
Displays QoS policy maps.