Match Ipv4 Destination Address - Cisco Catalyst 3650 series Command Reference Manual

match ipv4 destination address

To configure the IPv4 destination address as a key field for a flow record, use the match ipv4 destination
address command in flow record configuration mode. To disable the IPv4 destination address as a key field
for a flow record, use the no form of this command.
match ipv4 destination address
no match ipv4 destination address
Syntax Description
This command has no arguments or keywords.
Command Default
The IPv4 destination address is not configured as a key field.
Command Modes
Flow record configuration
Command History
Release
Cisco IOS XE 3.3SE
Usage Guidelines
A flow record requires at least one key field before it can be used in a flow monitor. The key fields distinguish
flows, with each flow having a unique set of values for the key fields. The key fields are defined using the
match command.
To return this command to its default settings, use the no match ipv4 destination address or default match
ipv4 destination address flow record configuration command.
Examples The following example configures the IPv4 destination address as a key field for a flow record:
Device(config)# flow record FLOW-RECORD-1
Device(config-flow-record)# match ipv4 destination address
Modification
This command was introduced.
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
match ipv4 destination address
447