Command Reference, Cisco Ios Xe Everest 16.5.1A (Catalyst 3650 Switches - Cisco Catalyst 3650 series Command Reference Manual

monitor session destination
This example shows how to configure RSPAN source session 1 to monitor a source interface and to configure
the destination RSPAN VLAN 900:
Device(config)# monitor session 1 source interface gigabitethernet1/0/1
Device(config)# monitor session 1 destination remote vlan 900
Device(config)# end
This example shows how to configure an RSPAN destination session 10 in the switch receiving the monitored
traffic:
Device(config)# monitor session 10 source remote vlan 900
Device(config)# monitor session 10 destination interface gigabitethernet1/0/2
This example shows how to configure the destination port for ingress traffic on VLAN 5 by using a security
device that supports IEEE 802.1Q encapsulation. Egress traffic replicates the source; ingress traffic uses IEEE
802.1Q encapsulation.
Device(config)# monitor session 2 destination interface gigabitethernet1/0/2 encapsulation
dot1q ingress dot1q vlan 5
This example shows how to configure the destination port for ingress traffic on VLAN 5 by using a security
device that does not support encapsulation. Egress traffic and ingress traffic are untagged.
Device(config)# monitor session 2 destination interface gigabitethernet1/0/2 ingress untagged
vlan 5
Related Commands
Command
monitor session
monitor session filter
monitor session source
show monitor

Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)

508
Description
Configures a new SPAN or RSPAN session.
Configures a FSPAN or FRSPAN session filter.
Configures a FSPAN or FRSPAN source session.
Displays information about all SPAN and RSPAN sessions.