Siemens SINUMERIK 840D sl Function Manual page 551

05.08
Remedy
© Siemens AG 2008 All Rights Reserved
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 05.2008 Edition
12: An attempt was made to enable the SBC function although this cannot
be supported for a parallel circuit configuration.
13: An attempt was made to enable the SS1 function although this cannot
be supported.
14: An attempt was made to enable the PROFIsafe communication function
although this cannot be supported.
15: An attempt was made to enable the motion monitoring function integra-
ted in the drive although this cannot be supported.
16: An attempt was made to enable the SH function although this cannot be
supported when the internal voltage protection (p1231) is enabled.
See also: p0970 (reset infeed parameters), p3900 (complete fast com-
missioning), r9771 (SI common functions (Control Unit)), r9871 (SI
common functions (Motor Module))
Re fault value = 1:
– Set the Safety Integrated password (p9761).
Re fault value = 2:
– Inhibit Safety Integrated and again reset the drive parameters.
Re fault value = 3:
– Simulation mode for the digital input ended (p0795).
Re fault value = 10, 11, 12, 13, 14, 15:
– Check whether there are faults in the safety function alignment
between the Control Unit and the Motor Module involved (F01655,
F30655) and if required, carry out diagnostics for the faults involved.
– Use a Motor Module that supports the functions "Safe standstill",
"Safe brake control", "PROFIsafe", "Drive–integrated motion moni-
toring functions".
– Upgrade the Motor Module software.
– Upgrade the Control Unit software.
Re fault value = 16:
– Inhibit the internal voltage protection (p1231).
See also: p9501 (SI motion enable safe functions), p9601 (SI enable
functions integrated in the drive (Control Unit)), p9620 (SI signal source
for SH/SBC/SS1 (Control Unit )), p9761 (SI password input), p9801
(SI enable functions integrated in the drive (Motor Module))
10.3 Safety messages for SINAMICS S120
Diagnostics
10-551