Siemens SINUMERIK 840D sl Function Manual page 392

Commissioning
9.1 HMI screens and softkeys
The SI machine data/parameters to define the encoder mounting arrangement
must be separately entered for the NCK and drive by the commissioning engineer.
The copy function has no effect for the drive parameters marked in the Table 8-2
"Parameters for SINAMICS S120".
Drive data is automatically saved after data has been copied. The data is saved for
all safety axes.
Fig. 9-2
Softkey "Confirm SI data"
After an drive/NCK RESET, the actual checksum is saved by pressing the softkey
Confirm SI data in the "Commissioning/NC/Safety–Integrated" screen and
acknowledging the following dialog box with "OK". From now on, SI data will be
monitored for any changes. Drive data is automatically saved after data has been
acknowledged.
Note
If the copy or confirm process is initiated in the screen form "Axis MD", the
particular operation is only carried out for the currently selected axis.
9-392
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 05.2008 Edition
Softkey Copy SI data for 840D sl
© Siemens AG 2008 All Rights Reserved
05.08