System Features - Siemens SINUMERIK 840D sl Function Manual

System Features

3.1 System requirements
S Software option "SINUMERIK Safety Integrated"
SI–Basic (including 1 axis/spindle, up to 4 SPL I/Os)
SI–Comfort (including 1 axis/spindle, up to 64 SPL I/Os)
SI axis/spindle (in addition for each axis /spindle)
SI axis/spindle package (in addition, 15 axes/spindles)
S SINUMERIK 840D sl; software release:
From 1.3.1 for safety functions integrated in the drive (SH/SBC via terminals,
Chapter 4)
From 1.3.2 for safety functions integrated in the system (Chapters 5 to 7)
Warning
!
From SINAMICS SW2.5 onwards, the following applies:
In a system configuration, the firmware versions of the DRIVE–CLiQ components
can only differ from the versions on the CF card, if either
a) the automatic upgrade/downgrade (parameter p7826) is deactivated, or
b) components with a new firmware version can no longer be downgraded to the
status of the version available on the CF card.
Scenario a) is not permitted when Safety Integrated is used. The automatic
upgrade/downgrade must not be disabled when Safety Integrated is used.
(automatic firmware update (p7826) must be equal to 1)
Scenario b) is only permissible if this combination has been explicitly approved by
the manufacturer.
S SINUMERIK 840D sl; all NCU types can be used.
S The measuring circuit cables must comply with the specifications of the SINAM-
ICS S120.
© Siemens AG 2008 All Rights Reserved
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 05.2008 Edition
3
6FC5800–0AM63–0YB0
6FC5800–0AM64–0YB0
6FC5800–0AC70–0YB0
6FC5800–0AC60–0YB0
3-43