Siemens SINUMERIK 840D sl Function Manual page 215

05.08
Example
SPL--SGA are written -- as F net data -- into the 1st sub--slot of the F--DO module
with PROFIsafe address: 100H.
F--DO module
PROFIsafe address: 100H
Fig. 7-18
As a result of the possibility of flexibly assigning the F net data of an F--DO module
to the SPL--SGA by combining the machine data now described (...OUT_FIL-
TER[n] and ...OUT_ASSIGN[n]), it is possible and also makes sense to use the
same PROFIsafe and sub--slot address a multiple number of times within the ma-
chine data:
S $MN_PROFISAFE_OUT_ADDRESS[0...max. Index]
possible and/or practical
Note
All machine data to connect an F--DO module to the SPL--SGA are associated
with one another through the common index of the machine data:
S $MN_PROFISAFE_OUT_ADDRESS[Index]
S $MN_PROFISAFE_OUT_FILTER[Index]
S $MN_PROFISAFE_OUT_ASSIGN[Index]
F net data filter
The F net data filter allows the selected SPL--SGA -- without any gaps -- to distrib-
uted across any F net data signals within the sub--slot.
The F net data filter is parameterized in the machine data:
S MD 13301: $MN_PROFISAFE_OUT_FILTER[Index] (F net data filter OUT)
Every selected SPL--SGA is assigned a filter bit in an increasing sequence. The
filter bits, which are used to transfer the SPL--SGA to the F net data signals,
should be set to 1. The filter bits of the SPL--SGA that are not to be transferred,
should be set to 0.
FFFF FFFFH is the default setting of the F net data filter; this means that all of the
selected SPL--SGA, are transferred from F net data signal 1 onwards (bit 0) into
the F net data of the F--DO module.
© Siemens AG 2008 All Rights Reserved
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) - - 05.2008 Edition
F net data signals:
F--DO addressing with sub--slot
Connecting Sensors/Actuators
7.2 Connecting I/O via PROFIsafe
64 33 32
2nd sub--slot [1] 1st sub--slot [0]
Assigning the 1st sub--slot:
..._OUT_ADDRESS[3] = 05 00 0100H
1
7-215