Siemens SINUMERIK 840D sl Function Manual page 530

Diagnostics
10.2 NCK safety alarms for SINUMERIK 840D sl
27221
Parameter
Explanation
Response
Remedy
Program
continuation
27222
Parameter
Explanation
Response
Remedy
Program
continuation
27223
Parameter
Explanation
10-530
SINUMERIK 840D sl/SINAMICS S120 SINUMERIK Safety Integrated (FBSI sl) – 05.2008 Edition
PROFIsafe: NCK F module MD %1[%2] unknown
%1 = MD name
%2 = MD field index
The F module parameterized in the specified machine data is unknown
under this PROFIsafe address in the S7 configuration.
Mode group not ready
Channel not ready
NC start inhibit in this channel
Interface signals are set
Alarm display
NC stop for alarm
Check the PROFIsafe addresses in the NCK–MD and S7–DP configu-
ration
Switch control system OFF and ON again.
PROFIsafe: S7 F module PROFIsafe address %1 unknown
%1 = PROFIsafe address
The F module with the specified PROFIsafe address has not been
parameterized as an F module in the NCK MD
Mode group not ready
Channel not ready
NC start inhibit in this channel
Interface signals are set
Alarm display
NC stop for alarm
Check the S7 PROFIBUS configuration. Register the module in the
NCK MD
Switch control system OFF and ON again.
PROFIsafe: NCK F module MD %1[%2] is not a %3 module
%1 = MD name
%2 = MD field index
%3 = module type
The F module parameterized in the specified NCK MD has not been
designated as an appropriate input/output module in the S7 PROFIBUS
configuration.
– %3 = INPUT: NCK F parameterization expects an INPUT module
– %3 = OUTPUT: NCK F parameterization expects an OUTPUT module
– %3 = IN/OUT: NCK F parameterization expects an INPUT/OUTPUT
module
© Siemens AG 2008 All Rights Reserved
05.08