Juniper EX4500 Hardware Manual page 186

EX4500 Switch Hardware Guide
164
EX6200 switch—Connect the cable to one of the ports labeled
Fabric and Routing Engine (SRE) module in slot 4 or 5 in an EX6210 switch.
EX8200 switch—Connect the cable to the port labeled
and Routing Engine (SRE) module in slot SRE0 in an EX8208 switch or on the
Routing Engine (RE) module in slot RE0 in an EX8216 switch.
These ports are configured as the DHCP server with the default IP address, 192.168.1.1.
The switch can assign an IP address to the management PC in the IP address range
192.168.1.2 through 192.168.1.253.
From the PC, open a Web browser, type http://192.168.1.1 in the address field, and
3.
press Enter .
On the J-Web login page, type root as the username, leave the password field blank,
4.
and click Login .
On the Introduction page, click
5.
On the Basic Settings page, modify the hostname, the root password, and date and
6.
time settings:
Enter the hostname. This is optional.
Enter a password and reenter the password.
Specify the time zone.
Synchronize the date and time settings of the switch with the management PC or
set them manually by selecting the appropriate option button. This is optional.
Click .
Next
Use the Management Options page to select the management scenario:
7.
NOTE: On EX4500, EX6210, and EX8200 switches, only the out-of-band
management option is available.
In-band Management—Use VLAN 'default' for management
Select this option to configure all data interfaces as members of the default VLAN.
Click . Specify the management IP address and the default gateway for the
Next
default VLAN.
In-band Management—Create new VLAN for management
Select this option to create a management VLAN. Click
name, VLAN ID, member interfaces, management IP address, and default gateway
for the new VLAN.
Out-of-band Management—Configure management port
Next .
Copyright © 2017, Juniper Networks, Inc.
on the Switch
MGMT
MGMT on the Switch Fabric
.
.
. Specify the VLAN
Next
.