Removing An Intraconnect Module From An Ex4500 Switch; Figure 63: Installing An Intraconnect Module In An Ex4500 Switch - Juniper EX4500 Hardware Manual

Related
Documentation

Removing an Intraconnect Module from an EX4500 Switch

Copyright © 2017, Juniper Networks, Inc.
When the status ( ) LED on the intraconnect module turns green, the module is ready
ST
for use.

Figure 63: Installing an Intraconnect Module in an EX4500 Switch

NOTE: If you have a Juniper J-Care service contract, register any addition,
change, or upgrade of hardware components at
https://www.juniper.net/customers/support/tools/updateinstallbase/
to do so can result in significant delays if you need replacement parts. This
note does not apply if you replace existing components with the same type
of component.
Removing an Intraconnect Module from an EX4500 Switch on page 199
Installing and Removing EX4500 Switch Hardware Components on page 132
The intraconnect module is installed horizontally on the rear of the switch. See
Panel of an EX4500 Switch" on page
remove the module.
CAUTION: Operating an EX4500 switch without the intraconnect module
or the Virtual Chassis module is not supported.
EX4500 switches running Junos OS Release 10.4R2 or later 10.4 releases will
not boot if you do not install the intraconnect module in the switch.
EX4500 switches running Junos OS Release 11.1R1 or later releases will not
boot if you install neither the intraconnect module nor the Virtual Chassis
module in the switch.
Before you begin removing the intraconnect module from an EX4500 switch:
Ensure that you have taken the necessary precautions to prevent ESD damage (see
"Prevention of Electrostatic Discharge Damage" on page
Have instructions and tools for removing the fan tray. If the fan tray is installed, you
must remove it as part of the procedure for removing the intraconnect module. After
Chapter 20: Replacing Interconnect Module
18. Use the procedure described in this topic to
281).
. Failure
"Rear
199