Figure 30: Attaching The Mounting Bracket Along The Front Of The Switch - Juniper EX4500 Hardware Manual

Copyright © 2017, Juniper Networks, Inc.
Read "General Safety Guidelines and Warnings" on page
to "Chassis Lifting Guidelines" on page
Remove the switch from the shipping carton (see
page 121).
Ensure that you have the following parts and tools available:
Phillips (+) screwdriver, number 2
2 mounting brackets and 20 mounting screws (provided in the accessory box shipped
with the switch)
Screws to secure the chassis to the rack (not provided)
Dust covers for ports
NOTE: One person must be available to lift the switch while another secures
the switch to the rack.
CAUTION: If you are mounting multiple units on the rack, mount the heaviest
unit at the bottom and mount the others from bottom to top in order of
decreasing weight.
To mount the switch on two posts in a rack:
Place the switch on a flat, stable surface.
1.
Align the mounting brackets along the front or rear of the side panels of the switch
2.
chassis depending on whether you are front-mounting or rear-mounting the switch.
See Figure 30 on page

Figure 30: Attaching the Mounting Bracket Along the Front of the Switch

260.
127.
Chapter 12: Installing the Switch
251, with particular attention
"Unpacking an EX4500 Switch" on
127