Table 27: Chassis Viewer For Ex4500 Switches - Juniper EX4500 Hardware Manual

EX4500 Switch Hardware Guide
Table 26: Chassis Viewer for EX4300 Switches (continued)
Field
Console port
USB port
Fan tray
Power supplies
PIC 1 slot

Table 27: Chassis Viewer for EX4500 Switches

Field
Front View
Interface status
56
Description
The Console port (RJ-45) is used to connect the switch to a management console or to a console
server.
Indicates the USB port for the switch.
NOTE: We recommend that you use USB flash drives purchased from Juniper Networks for your
EX Series switch.
Mouse over the fan tray icons to display name, status, and description information.
Mouse over the power supply icons to display name, status, and description information.
The rear panel of a 24-port and a 48-port EX4300 switch has four (built-in) 40-Gigabit QSFP+
ports, and the rear panel of an EX4300-32F switch has two (built-in) 40-Gigabit QSFP+ ports, in
which you can install QSFP+ transceivers. Mouse over the ports to view the details of the ports.
After you install a transceiver in the port, the following colors denote the interface status:
Green—Interface is up and operational.
Yellow—Interface is up but is not operational.
Gray—Interface is down and not operational.
For QSFP+ ports, the interfaces appear dimmed if no transceiver is inserted. The chassis viewer
displays
Transceiver not plugged in
When a QSFP+ port is configured as a Virtual Chassis Port (VCP), the following colors denote the
VCP status:
Green—VCP is up and operational.
Yellow—VCP is up but is not operational.
Gray—VCP is down and not operational.
Description
In the image, the colors listed below denote the interface status:
Green—Interface is up and operational.
Yellow—Interface is up but is nonoperational.
Gray—Interface is down and nonoperational.
Mouse over the interface (port) to view more information.
For a Virtual Chassis configuration, select the switch to view the interface status.
If an SFP+ uplink module is installed in the switch, mouse over the interface (ports) on the
module for more information.
For SFP and SFP+ ports, the interfaces appear dimmed if no transceiver is inserted. The chassis
viewer displays
Transceiver not plugged-in
when you mouse over the port.
when you mouse over the port icon.
Copyright © 2017, Juniper Networks, Inc.