Figure 64: Removing An Intraconnect Module From An Ex4500 Switch - Juniper EX4500 Hardware Manual

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
NOTE: Do not use the captive screws to pull the module out from the
chassis. Pull from underneath the front edge of the module.
Using both hands, gently slide the intraconnect module halfway out of the chassis.
7.
Place one hand under the module to support it and slide it completely out of the
8.
chassis.
Place the intraconnect module in an antistatic bag or on an antistatic mat placed on
9.
a flat, stable surface.
Promptly install the replacement intraconnect module. See
Module in an EX4500 Switch" on page

Figure 64: Removing an Intraconnect Module from an EX4500 Switch

NOTE: If you have a Juniper J-Care service contract, register any addition,
change, or upgrade of hardware components at
https://www.juniper.net/customers/support/tools/updateinstallbase/
to do so can result in significant delays if you need replacement parts. This
note does not apply if you replace existing components with the same type
of component.
Installing an Intraconnect Module in an EX4500 Switch on page 197
Installing and Removing EX4500 Switch Hardware Components on page 132
Chapter 20: Replacing Interconnect Module
197.
Press on both sides of the chassis
to disengage the Intraconnect module.
(Don t pull on the captive screws!)
"Installing an Intraconnect
Captive screw
. Failure
201