Figure 31: Mounting The Switch On Two Posts In A Rack - Juniper EX4500 Hardware Manual

EX4500 Switch Hardware Guide
Related
Documentation
128
Align the bottom holes in the mounting brackets with holes on the side panels of the
3.
switch chassis.
Insert mounting screws into the aligned holes. Tighten the screws.
4.
Ensure that the other holes in the mounting brackets are aligned with the holes in the
5.
side panels. Insert a screw in each hole and tighten the screws.
Have one person grasp both sides of the switch, lift the switch, and position it in the
6.
rack, aligning the mounting bracket holes with the threaded holes in the rack or cabinet
rail. Align the bottom hole in both the mounting brackets with a hole in each rack rail,
making sure the chassis is level. See

Figure 31: Mounting the Switch on Two Posts in a Rack

Have a second person secure the switch to the rack by using the appropriate screws.
7.
Tighten the screws.
Ensure that the switch chassis is level by verifying that all screws on one side of the
8.
rack are aligned with the screws on the other side.
We recommend that you insert dust covers in any unused ports.
9.
Connecting Earth Ground to an EX Series Switch on page 135
Connecting AC Power to an EX4500 Switch on page 141
Connecting DC Power to an EX4500 Switch on page 144
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 159
Figure 31 on page
Mounting rack
Mounting bracket
128.
Copyright © 2017, Juniper Networks, Inc.