Juniper EX4500 Hardware Manual page 46

EX4500 Switch Hardware Guide
Table 6: LCD Panel Menu Options in EX4500 Switches (continued)
Menu
MAINT (Maintenance Menu)
24
Description
The Maintenance menu has the following options to configure and troubleshoot
the switch:
SYSTEM HALT?—Choose one of the following:
Press Enter to halt the switch. Press Enter again to confirm the halt.
Press Menu to go to the next option in the Maintenance menu.
SYSTEM REBOOT?—Choose one of the following:
Press Enter to reboot the switch. Press Enter again to confirm the reboot.
Press Menu to go to the next option in the Maintenance menu.
LOAD RESCUE?—Choose one of the following:
Press Enter to roll back the switch to the previous valid configuration. Press
Enter again to confirm the rollback.
Press Menu to go to the next option in the Maintenance menu.
REQUEST VC PORT?—Choose one of the following:
Press the Enter button to configure an uplink module port or a network port
to be a Virtual Chassis port (VCP) or to delete a VCP from the switch
configuration (when you delete the VCP, the port is reset to an uplink module
port or network port).
NOTE: This option is supported only on EX4500 switches in a Virtual Chassis
configuration running Junos OS Release 11.1 or later.
This option is not supported on standalone EX4500 switches.
Press the Menu button to go to the next option in the Maintenance menu.
FACTORY DEFAULT?—Choose one of the following:
Press Enter to restore the switch to the factory default configuration. Press
Enter again to confirm the restoration. The LCD panel flashes a success or
failure message and returns to the Idle menu.
Press Menu to go to the next option in the Maintenance menu.
ENTER EZSETUP?—Choose one of the following:
Press Enter to launch EZSetup. Press Enter again to confirm the launch.
EZSetup configures DHCP and enables the J-Web user interface on the switch.
The LCD panel flashes a success or failure message for approximately 10
seconds and returns to the Idle menu.
NOTE: You can use EZSetup only on a standalone switch that is in the factory
default configuration.
For information about EZSetup, see
Switch (J-Web Procedure)" on page
Press Menu to go to the next option in the Maintenance menu.
EXIT MAINT MENU?—Choose one of the following:
Press Enter to exit the Maintenance menu.
Press Menu to return to the SYSTEM HALT option.
You can disable the Maintenance menu or the options in the Maintenance menu
in the LCD panel. See "Configuring the LCD Panel on EX Series Switches (CLI
Procedure)" on page 166.
"Connecting and Configuring an EX Series
162.
Copyright © 2017, Juniper Networks, Inc.