Figure 196 Configure A Pri Trunk - Aa - ZyXEL Communications X6004 User Manual

Chapter 17 Outbound Line Group

Figure 196 Configure a PRI Trunk - AA

Figure 197 Configure a PRI Trunk - Direct
Each field is described in the following table.
Table 76 Configure a PRI Trunk
LABEL
PRI Trunk Setting
Option
Type of Number
Calling Party
Number Prefix
Directory Number
Available
Interface
212
DESCRIPTION
Specify the service type for this trunk.
Select DDI/DID (Direct Dialing In) when you want people to use a "direct number"
to dial an outgoing call. You can also specify a prefix number in the caller number
that might be required by your telephone company for outgoing calls using DDI/
DID. See DDI (Direct Dial In) on page 205
Select AA (Auto-Attendant) for all calls coming through this interface will be
switched to the Auto-Attendant system first. See
more information.
Select Direct for all calls coming through this interface and from trusted callers will
be forwarded to extensions. See
more information.
Select the type for the prefix number which might be required by your telephone
company to make outgoing calls. The options you can select are UNKNOWN,
INTERNATIONAL, NATIONAL, NETWORK, SUBSCRIBER, ABBREVIATED.
Enter a number to add in the beginning of the outgoing caller's numbers using this
trunk line.
Enter one of your ISDN numbers registered to your telephone company. When
you make a call over this outbound line from an extension that is NOT listed in the
DDI mapping table, the Directory Number is the number that displays on the
callee's caller ID.
This column displays the available slots and ports on the X6004. Click one slot
and port and then click the Right icon if you want to add it to this group.
for more information.
Section 18.1 on page 231
Calling Directly to an Extension on page 206
X6004 User's Guide
for
for