Auto-Attendant For Incoming Bri Calls - ZyXEL Communications X6004 User Manual

Chapter 17 Outbound Line Group

17.5.2 Auto-Attendant for Incoming BRI Calls

Use this screen to select which auto-attendant should be used with this outbound line group.
The fields in this screen are the same as the fields in the PRI trunk auto-attendant screen. Refer
to Section 17.4.2 on page 213
17.6 Add/Edit SIP Trunk
The screens for editing or adding SIP trunks on the X6004 contain the same fields. This
section uses the screen "adding a SIP truck" for an example. Click the Add (or Edit) icon in
the SIP Trunk section of the Outbound Line Group configuration screen to view the screen
as shown.
Figure 201 Add/Edit SIP Trunk
Each field is described in the following table.
Table 80 Add/Edit SIP Trunk
LABEL
Machine ID
Group Name
Description
Apply
Back to Outbound
Group/Cancel
17.6.1 Configure a SIP Trunk
Use this screen to configure a SIP trunk. Click the Advanced icon in the SIP Trunk section of
the Outbound Line Group configuration screen to view the screen as shown.
216
for detailed field descriptions.
DESCRIPTION
Select the ID of the X6004 on which you want to configure the SIP trunk. This is an
internal name (not configurable) of the X6004. Only one choice is shown if you
have not configured ZyStack.
This field is not available when editing a SIP trunk configuration.
Type the name of this SIP trunk. You can use alpha-numeric characters and
spaces are not allowed.
Type the description for this SIP interface. You can use alpha-numeric characters
and spaces are allowed.
Click this to save your changes.
Click this to go to the Outbound Line Group screen without saving your changes.
X6004 User's Guide