Auto-Attendant For Incoming Pri Calls - ZyXEL Communications X6004 User Manual

Table 76 Configure a PRI Trunk
LABEL
Used Interface
DDI/DID Mapping
DDI/DID Mask
DDI/DID Number,
Extension
Number
Add
Delete
Calling Party
Number
Length
Trusted Peer
Apply
Cancel

17.4.2 Auto-Attendant for Incoming PRI Calls

Use this screen to select which auto-attendant should be used with this outbound line group.
See Chapter 18 on page 231
Attendant icon in the in the PRI Trunk section of the Outbound Group configuration screen
to view the screen as shown.
Figure 198 AA for Incoming PRI Calls
Each field is described in the following table.
Table 77 AA for Incoming PRI Calls
LABEL
Apply AA
Apply
Cancel
X6004 User's Guide
DESCRIPTION
This column displays the ports currently configured for this outbound line group.
Click one port and click the Left icon if you want to remove it from the group.
If you configure more than one interfaces in this outbound line group, the X6004
check and pick one of them available for an outgoing call.
Use this section to configure your DDI/DID mapping table.
Enter a number (1~20) to identify the extension mapping digits from right to left, so
a DDI/DID mask of 2 applied to the incoming ISDN number 555-123456 would
identify the numbers 56.
Enter the DDI/DID number (like the example 56 above) and its associated
extension number (for example, 6012).
Click this to add a DDI/DID mapping rule.
Click this to delete a DDI/DID mapping rule.
The settings in this section are optional. Leave them empty to allow all incoming
calls. Alternatively, you can define trusted caller number(s) to filter incoming
callers. Then the X6004 only forwards the calls that their caller numbers are listed
in the trusted caller table.
Enter a number (1~20) to identify the phone number length for trusted callers.
Enter a phone number you accept the caller to dial extensions using this outbound
group. Click the Add icon to add a number into the trusted caller table. Click the
Delete icon to remove a number.
Click this to save your changes.
Click this to go to the Outbound Line Group screen without saving your changes.
for information on configuring auto-attendant. Click the Auto-
DESCRIPTION
Select an Auto-Attendant profile used for the calls incoming through this PRI trunk.
Click this to save your changes and to apply them to the X6004.
Click this to go to the Outbound Group screen without saving your changes.
Chapter 17 Outbound Line Group
213