Table of Contents
Advertisement
18.3.1 Add/Edit FXO Trunk
The screens for editing or adding FXO trunks on the X6004 contain the same fields. Only the
screen used to add FXO trunks is shown below. Click the Add (or Edit) icon in the FXO
Trunk section of the Outbound Line Group configuration screen to view the screen as
shown.
Figure 143 Add/Edit FXO Interface
Each field is described in the following table.
Table 63 Add/Edit FXO Interface
LABEL
Machine ID
Group Name
Description
Apply
Back to Outbound
Group/Cancel
18.3.2 Configure an FXO Trunk
Use this screen to configure an FXO Trunk. Click the Advanced icon in the FXO Trunk
section of the Outbound Line Group configuration screen to view the screen as shown.
Figure 144 Configure an FXO Interface
X6004 User's Guide
DESCRIPTION
Select the ID of the X6004 on which you want to configure the FXO interface. This
is an internal name (not configurable) of the X6004. Only one choice is shown if
you have not configured ZyStack.
This field is not available when editing an FXO configuration.
Type the name of this FXO interface. You can use alpha-numeric characters and
spaces are not allowed.
Type the description for this FXO interface. You can use alpha-numeric characters
and spaces are allowed.
Click Apply to save your changes.
Click this to go to the Outbound Line Group screen without saving your changes.
Chapter 18 Outbound Line Group
165
Advertisement
Table of Contents
