Network Deployment - ZyXEL Communications X6004 User Manual

C
H A P T E R
5.1 Overview
This chapter shows you how to deploy the X6004 on your network, using the Configuration >
Network screens.
The following diagram shows a sample network deployment of the X6004. The WAN port is
connected to a DMZ interface on the default gateway router. The X6004 uses the WAN
interface to connect to a SIP server at the ITSP. SIP IP devices use the WAN IP address of the
X6004 to connect to it.
On the LAN, SIP IP phones use the LAN IP address of the X6004 to connect to it.
Figure 100 Network Deployment Overview
5.1.1 What You Can Do in the Network Screens
• Use the LAN screen to set up the LAN IP address of the X6004. See
105.
• Use the WAN screen to set up a connection with the ISP or the default gateway router. See
Section 5.3 on page
• Use the DDNS screen to configure your Dynamic DNS settings. See
106.
• Use the NTP screen to configure time settings on the X6004. See
• Use the Static Route screen to look at static routes in the X6004. See
109.
X6004 User's Guide

Network Deployment

Internet
DMZ
105.
5
ITSP
Section 5.2 on page
Section 5.4 on page
Section 5.5 on page
Section 5.6 on page
108.
103