The Auto Callback Screen - ZyXEL Communications X6004 User Manual

Chapter 21 Call Services
This function works only when the callee uses an analog phone connected to
X6004's FXS port, a ZyXEL softphone such as V100 or a ZyXEL IP phone
such as V500.
Figure 239 Distinctive Ring
The following table describes the labels in this screen.
Table 101 Distinctive Ring
LABEL
Active
Ring Tone
Internal Call
SIP Trunk
FXO
PRI
BRI
Apply
Reset

21.6 The Auto Callback Screen

The auto callback feature is used when a caller encounters a busy signal when dialing one of
the extensions. The caller can then request the X6004 to automatically call both parties when
both of the extensions are free.
Click Configuration > PBX > Call Services > Auto Callback to configure the auto callback
feature.
264
DESCRIPTION
Select this to activate the distinctive ring feature.
Select a ring tone (1~12) and press Playback to listen to the ring tone on the
computer that you are using to configure the X6004.
Select the ring tone for internal calls (calls from one X6004's extension to another
X6004's extension).
Select the ring tone for calls coming in from the SIP trunk (for example your
connection to the ITSP).
Select the ring tone for calls coming in from the FXO trunk (for example your
connection to the PSTN).
Select the ring tone for calls coming in from the PRI trunk (for example your
connection to an ISDN T1/E1 line).
Select the ring tone for calls coming in from the BRI trunk (for example your
connection to an ISDN BRI line).
Click this to save your changes.
Click this to set every field in this screen to its last-saved value.
X6004 User's Guide