Adding A Static Route - ZyXEL Communications X6004 User Manual

Chapter 5 Network Deployment
The following table describes the labels in this screen.
Table 16 Configuration > Network > Static Route
LABEL
Delete
Destination
Network
Subnet Mask
Gateway IP
Network
Interface
Add/Delete

5.6.2 Adding a Static Route

Click the Add icon in the Configuration > Network > Static Route screen. The screen
shown next appears. Use this screen to configure the required information for a static route.
Figure 107 Configuration > Network > Static Route > Add
The following table describes the labels in this screen.
Table 17 Configuration > Network > Static Route > Add
LABEL
Add a New
Static Route
Destination
Network
Subnet Mask
Gateway IP
Network
Interface
Apply
Cancel
110
DESCRIPTION
Select this checkbox and click Delete to remove this static route from the X6004.
This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
This is the subnet mask of the static route.
This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN port. The gateway helps forward packets to
their destinations.
This field specifies the interface of the static route.
Use the Add and Delete icons to create or remove static routes respectively.
DESCRIPTION
This parameter specifies the IP network address of the final destination. Routing is
always based on network number.
Select the IP subnet mask.
Enter the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN port. The gateway helps forward packets to
their destinations.
This is a read-only field indicating that this static route is configured for the LAN.
Click Apply to save your changes back to the X6004.
Click Cancel to begin configuring this screen afresh.
X6004 User's Guide