The E-Mail Screen - ZyXEL Communications X6004 User Manual

Chapter 6 Server
Table 27 Configuration > PBX > Server Configuration > Server > Feature Code (continued)
LABEL
Call Forward No
Answer VM
Call Transfer
Direct Pickup
DND On
DND Off
DND IVR
Follow Me On
Follow Me Off
Group Pickup
Personal IVR
Voice Mail
Apply
Reset

6.9 The E-Mail Screen

Use this screen to configure the mail server information through which the X6004 sends voice
mails and CDR (Call Detail Record) files to the email addresses which you configured in
extension voice mail (see
310) screens. Click Configuration > PBX > Server Configuration > Server > E-Mail to
view the screen as shown next.
Figure 121 Configuration > PBX > Server Configuration > Server > E-Mail
Each field is described in the following table.
Table 28 Configuration > PBX > Server Configuration > Server > E-Mail
LABEL
E-Mail Server
Sender
128
DESCRIPTION
Enter the code to forward an incoming call to voice mail system when the call was
forwarded to this extension and no one answers the call.
Enter the code used to transfer calls.
Enter the code used to pick up calls for your extension from a different extension.
Enter the code used to turn the Do Not Disturb feature on for this extension.
Enter the code used to turn the Do Not Disturb feature off for this extension.
Enter the code used to edit Do Not Disturb settings at an extension.
Enter the code used to turn the Follow Me feature on for this extension.
Enter the code used to turn the Follow Me feature off for this extension.
Enter the code used to activate group pickup for this extension.
Enter the code used to edit personal configuration for an extension via the handset.
Enter the code used to access voice mail on the X6004.
Click this to save your changes.
Click this to set every field in this screen to its last-saved value.
Section 13.3.8 on page
DESCRIPTION
Specify a mail server's IP address.
Specify the sender's email address.
173) and CDR (see Section 26.2 on page
X6004 User's Guide