Component Check - APRILIA SR MAX 125 ie Service Station Manual

Suspensions
- Take out the oil seal using the appropriate tools.
- Fit the tie rod into the oil seal.
- Insert in sequence the two half-rings per Ø 35-
mm stems.
Specific tooling
020487Y Fork oil seal extractor
- Hold the tie rod manually so that it does not fall
into the fork leg and/or that both half-rings are not
in their position.
- Fit the bell.
- Tighten the nut until it stops.
- Act on the tool until the oil seal is completely re-
moved.
Specific tooling
020487Y Fork oil seal extractor
- Remove the hydraulic rod with the corresponding
sealing gasket, the spring and the stop bushing.

COMPONENT CHECK

CAUTION
CLEAN ALL THE COMPONENTS THOROUGHLY.
SUSP - 208
SR MAX 125 ie