Engine
Characteristic
Valve clearance
Intake: 0.10 mm Exhaust: 0.15 mm
Refitting the rocker-arms cover
- Refit the cylinder head cover and tighten the 5
clamping screws to the prescribed torque.
- Make sure the gasket is positioned properly.
Locking torques (N*m)
Tappet cover screws
Refitting the intake manifold
- Fit the intake manifold and do up the three
screws.
Locking torques (N*m)
Intake manifold screws
Crankcase - crankshaft
crankshaft
Splitting the crankcase halves
crankcase halves
AXIAL CLEARANCE CHECK
- Before opening the engine crankcase, it is ad-
visable to check the axial clearance of the crank-
shaft. Use a specific tool to check axial clearance.
- Higher clearances are signs of wear on the crank-
shaft - crankcase supporting surfaces.
Specific tooling
020262Y Crankcase splitting plate
ENG - 142
5 - 6 Nm
11 to 13
SR MAX 125 ie