Removing The Hub Bearings; Removing The Wheel Axle Bearings - APRILIA SR MAX 125 ie Service Station Manual

SR MAX 125 ie

Removing the hub bearings

- Check the state of the bearings being examined (wear, clearance and noisiness). If faults are detected,
do the following.
- Use the specific bearing extractor to remove the three 15 mm bearings (2 in the crankcase and 1 in
the hub cover).
Specific tooling
001467Y013 Calliper to extract ø 15-mm bearings

Removing the wheel axle bearings

- Take out the clip on the outside of the hub cover.
- Support the hub cover and expel the bearing.
By means of the appropriate tools, remove the oil guard as in the figure.
Specific tooling
020376Y Adapter handle
020477Y 37 mm adaptor
020483Y 30 mm guide
020359Y 42 x 47-mm adaptor
020489Y Hub cover support stud bolt kit
Engine
ENG - 111