Refitting The Transmission Cover - APRILIA SR MAX 125 ie Service Station Manual

SR MAX 125 ie
- Fit the steel shim in contact with the bushing and
the stationary drive pulley.
- Install the appropriate tool as described in the re-
moval phase.
-Tighten the nut with washer to the prescribed tor-
que.
Specific tooling
020626Y008 Driving pulley lock wrench
Locking torques (N*m)
Drive pulley nut
75 - 83

Refitting the transmission cover

- Check that there are two alignment dowels and
that the sealing gasket for the oil sump on the
transmission cover is adequately fitted.
- Refit the cover and tighten the «12» screws to the
specified torque.
- Refit the steel washer and the driven pulley nut.
- Tighten the nut to the prescribed torque using the
lock wrench and the torque wrench tools.
- Refit the plastic cover.
Specific tooling
020423Y Driven pulley lock wrench
Locking torques (N*m)
Transmission cover screws
ley shaft nut
54 ÷ 60
End gear
Driven pul-
11 to 13
Engine
ENG - 109